The shipper's gate agent checks the tank markings on your DOT 407 and sees a pressure test date that expired last month. The load is rejected, the driver sits, and the dispatcher is left asking who was supposed to track it. Cargo tank testing is not hard to understand. It is hard to keep track of across a fleet. This guide covers the DOT 407 and DOT 412 inspection and test cycle, then shows how Truck Inspection & Maintenance Management Software puts every due date on a calendar and every report on the trailer's record. Start free and put your first tanker on a test calendar.
DOT 407 · DOT 412 · Cargo Tank Testing
Tanker Trailer Inspection Compliance Guide 2027: DOT 407 & 412
Annual inspections, 5-year pressure tests and thickness checks all run on different clocks. Truck Inspection & Maintenance Management Software gives each tank its own test calendar and keeps every report with the trailer.
Annualexternal visual inspection and leakage test
5 yearstypical interval for pressure test and internal visual
1 recordper tank, with every test report attached
DOT 407 vs DOT 412: Know Which Tank You Are Testing
Both are specification cargo tanks under 49 CFR Part 178, and both fall under the same periodic testing rules in Part 180. They differ in design and typical cargo, so check each tank's specification plate rather than assuming.
DOT 407
Chemical and industrial liquids
- Built for higher working pressure than non-spec tanks
- Common for flammable and other regulated liquids
- Subject to periodic pressure and leakage testing
DOT 412
Corrosive liquids
- Built for corrosive cargo such as acids
- Often lined or built for corrosion resistance, so thickness and lining checks matter
- Subject to the same periodic test cycle
General summary only. Design pressure, materials and cargo limits are on your tank's specification plate and manufacturer's data.
The Testing Calendar: What Falls Due and When
Think of each tank as running a five-year loop. Some tests repeat every year, and the heavy ones land together at the end of the cycle.
Year 1VK
Year 2VKT*
Year 3VK
Year 4VKT*
Year 5VKIP
*Thickness testing is more frequent for certain tanks, such as unlined tanks hauling materials corrosive to the tank. Your own intervals depend on tank construction and cargo, so confirm them in 49 CFR 180.407 or with your Registered Inspector.
The Seven Marking Codes, Explained
After each test, the tank is stamped with the date and a letter code. Gate agents and roadside inspectors read these first.
V
External visualShell, piping, valves and fittings checked for damage and leaks. Typically yearly.
K
Leakage testChecks that product lines and closures hold. Typically yearly.
I
Internal visualInterior inspected for corrosion and defects. Typically every 5 years.
P
Pressure testTank is tested at a specified pressure. Typically every 5 years.
T
Thickness testWall thickness measured to catch wear. Interval varies by tank.
L
Lining inspectionApplies to lined tanks. Confirms the lining is intact.
UC
Upper couplerInspection of the fifth-wheel connection area on the tank.
A tank with a missing or out-of-date code is exactly what causes rejected loads. Book a demo to see every code tracked per trailer.
Before the Registered Inspector Arrives: Readiness Checklist
Testing is done by qualified personnel, and failures found on test day cost you a shop visit. Run this check a week ahead.
✓Tank is cleaned and safe for entry or testing
✓Specification plate is legible
✓Gaskets, seals and valve seats checked
✓Open defects from DVIRs are repaired
✓Emergency shutoffs and vents work
✓Previous test reports are on hand
Put Every Tank on a Calendar Today
Start a free trial and add one tanker with its last test dates. Truck Inspection & Maintenance Management Software schedules the next ones and keeps the reports with the trailer.
How TIM Keeps the Tank Record Complete
The test is only half the job. The other half is being able to show it. TIM turns the calendar into a routine.
1Add the tankSpec, plate details and last test dates go on the trailer record.
2Dates scheduledEach test type gets its own next-due date.
3Reminders sentDue dates surface before they pass, not after.
4Findings become workA failed test item turns into a work order for repair.
5Report filedThe test report is stored against the trailer for the next audit.
What a Complete Tank Record Holds
When a customer or inspector asks for proof, this is the file you want to hand over in one click.
Tank record: one trailer, one place
IdentitySpec (407 or 412), serial, plate details
Test historyEach V, K, I, P, T, L and UC date with the inspector's report
Next dueThe upcoming date for every test type
RepairsWork orders raised from findings, with parts and labor
Daily defectsDVIR findings, owners and verified fixes
Frequently Asked Questions
How often does a DOT 407 or 412 tank need testing?
Under 49 CFR Part 180, Subpart E, the external visual inspection and leakage test are typically annual, and the pressure test and internal visual are typically every five years. Thickness and lining checks depend on the tank and cargo. Confirm your tank's exact schedule in the current regulation.
Start free and track every interval.
Who can perform these inspections and tests?
Periodic tests are carried out by qualified personnel, including a Registered Inspector for certain tests. Your shop or a third-party facility will tell you which person is required for each test type.
What happens when a tank fails a test?
The tank should not be used in the regulated service until the problem is corrected and the test is repeated or passed. In TIM, the finding becomes a work order tied to the trailer, so the repair and the retest stay on the same record.
How long should test records be kept?
Part 180 sets retention requirements for test and inspection reports, generally tied to the next test of that type. Check the current text for your situation. TIM stores reports with the trailer so they are there when needed.
Book a demo to see tank records in action.
Scheduled · Reminded · Recorded
Stop Finding Out a Test Is Overdue at the Gate
Truck Inspection & Maintenance Management Software gives every DOT 407 and 412 tank its own calendar and a record that is ready when someone asks. Start free to add your first tanker, or book a demo to map your whole tank fleet.
No credit card required. Free for up to 3 trucks.